DA

Electrician in Børkop and Vejle

Authorized electrical contractor for homes, businesses and farms. We cover the Triangle Region, up to 30 km from Børkop.

Authorized electrical contractor. Open Mon-Fri 8-16, urgent jobs by arrangement.

Electrical Contractor
Verify in the Danish Safety Technology Authority register
ABB EV charger mounted on a brick wall with the supply cable in galvanized conduit

EV charger installation

We install charge points for homes and businesses, from a single wallbox in the carport to several charging points in a car park. Cables are run neatly and safely, indoors or out, and the charger goes where it is easy to use every day.

Before installing, we check whether the supply cable and panel can take the extra load and whether load balancing is needed. The charger gets its own circuit with the correct residual current protection, and we test the installation before handover.

We advise on power (11 or 22 kW), placement and app control, and we can install a charger you have already bought.

Live, neutral and earth conductors connected in a terminal block at a ceiling light point

Installation and earth testing

An electrical installation is not finished until it has been measured and tested. We test all the work we do before handover, and you get the results in writing.

  • Continuity of the protective (earth) conductor to sockets, lights and equipment
  • Insulation resistance between conductors and to earth
  • Earth resistance and earth electrode
  • Residual current device (RCD): trip time and trip current
  • Polarity, phase sequence and fault current

The test can also be booked on its own, for example when buying or selling a house, in older homes, after a renovation or when the RCD trips for no obvious reason.

Solar panel mounting rails on a tiled roof

Solar and home battery

From rails on the roof to the connection in the panel. We install and connect PV systems and battery storage, notify the grid company and test everything before it goes into operation.

Want to know if your system can supply the house during a power cut? We offer an off-grid test where we simulate the grid and test disconnection and island operation.

Voltage measurement in an older switchboard with screw fuses and an RCD

Fault finding and repair

Power cuts out, a breaker trips, a socket is dead. We find the fault and fix it so the installation is safe again, and we document what was done.

We measure our way through the panel and out into the installation until we find the cause, so it is not just the symptom that gets removed. Older panels with screw fuses and RCDs get checked at the same time.

Panels, sockets and lighting

Consumer unit replacement, new circuits, RCD protection, extra sockets, outdoor sockets and lighting indoors and out. Also as part of renovations and extensions.

Business, retail and office

New installations, machine relocation, periodic inspection and minor panel rebuilds for shops, workshops, offices and farms. Work is planned to disturb operations as little as possible.

Urgent call-out

For power failures or faults that cannot wait, we come out at short notice within 30 km of Børkop. Call and we agree a time.

How it works

1. You call or write and describe the job.

2. We give a price or an hourly rate before we start.

3. We do the work, test the installation, tidy up and document what was done.

Where we work

We are based in Børkop between Vejle and Fredericia and cover the whole Triangle Region: Vejle, Fredericia, Kolding, Middelfart, Børkop, Brejning, Gårslev, Skærup, Smidstrup, Egtved, Jelling, Give and Juelsminde. A bit further away? Call anyway, it can usually be arranged.

Call or write to us about the job. We reply quickly and give a price before we start.

Authorized electrical contractor. Open Mon-Fri 8-16, urgent jobs by arrangement.